FLOW SENSOR 3/4 BRASS MATERIAL 60mm cable, YF-B6
The YF-B6 Water Flow Sensor is a flow sensor that utilizes the Magnetic Hall Effect to determine how much liquid is passing through. It is rated for between 1 and 30 litres per minute at a pressure of 1.5 MPa, and is ideal for a wide range of different projects involving the flow of liquids, such as watering the garden, brewing beer or simply keeping track of home water usage.
This sensor can be installed both horizontally and vertically, and has an operating voltage of between 3V and 24V DC. It operates on a duty cycle of about 50%, with a max pulse output voltage of >4.7V and a minimum of <0.5V at up to 15mA. These features enable it to be highly diverse in its usage, making it a top choice amongst our customers who are looking to precisely measure or control the flow of water or other liquids.
Specification :
Thread size :DN20, G3/4” (BSP) , male.
Flow hole: 14mm (diameter)
Voltage: DC4.5-18v
Body Material: brass
Flow rate : 1~30L/min
Flow Pulse: F(Hz)=8.1*Q – 3(+/-10%) Q=L/min
Max. Working Current : 10mA (DC5 V)
Min. Working Voltage: DC 4.5V
Working Voltage: DC 4.5V~18V
Load Capacity: =10 mA (DC 5 V)
Insulation resistance: over 100M Ohm
Max pressure: 1.75mpa
Suitable for liquid : water.(less than 60 cel. degree)
Wire Connection
– Terminal 1 (Red): VDD +
– Terminal 2 (Black): GND -
– Terminal 3 (Yellow): Signal VOut (GND Referenced/Open Drain , i.e. Requires Pull-Up)
Reference: ARDREALTIMECLOCK
Brand: Hytronic
DS1302 Real Time Clock Module (without battery inside )
Reference: RAB1000
Brand: Hytronic
The LilyGO TTGO LoRa32 is an ESP32 based microcontroller board with a built-in SX1276 LoRa chip and a 0.96 inch OLED display. The board is easily programmable through the CP2102 USB to serial convertor and can also be used as an Arduino. The board has a micro USB connector for programming and/of power supply purposes (micro USB cable is not included).
Reference: WEMOSD1
Brand: Hytronic
WeMos- D1 R2 WiFi ESP8266 Development Board is programmable via Arduino IDE. This is an ESP8266 based WiFi enabled microprocessor unit on a Arduino-UNO footprint. That means the board looks and works (in most cases) like an UNO. Several shields, sensors and output devices that are manufactured for the Arduino platform will work on the WeMos-D1R2 with the...
